Log:

Kreg Tool PRS1020

Téléchargements : 45 Taille : 4 mb    Fabricant : Kreg Tool  
Catégorie : Menuisiers Plate

Locate the two Support Struts (#7) and align them to the pre-drilled holes in the bottom of the Router Table Top. Mount the struts to the top using the eight .” Coarse Thread Screws (#16). Be careful not to over tighten. Note: To avoid damaging the table’s surface, be sure not to use the longer 1-1/4” screws (#11) on this step. Use the curved tab on the Insert Plate Levelers (#8) to locate each Leveler in the corner of the Insert Plate opening and fasten them in to place using three 1-1/4” coars





catégories